MIL-C-80036C
N a m e p l a t e , if different (see 3.10.2).
w.
Hour meter, i f required (see 3.11).
x.
First article inspection, if different (see 4.3).
y.
Q u a l i t y conformance inspection, if different (see 4.4).
z.
aa.
If preservation, packing, and marking in accordance with
MIL-W-45562 is required, specify level required (see
5.1).
C o n t r a c t data requirements.
R e q u i r e d technical data such as
6.2.2
o p e r a t o r ' s manuals, parts l i s t s , w i r i n g diagrams, examination, a n d test
r e p o r t s , and other instructions for operation and maintenance should be
specified on a DD Form 1423, C o n t r a c t Data Requirements List, incorporated
i n t o the contract.
6 . 3 F i r s t a r t i c l e . W h e n first article inspection is required, the item
t o be tested should be the first item offered for acceptance under the con-
T h e contracting officer should include specific instructions in ac-
tract.
q u i s i t i o n documents regarding arrangements for examination, test, and ap-
proval of the first article.
P a r a g r a p h 3.2.5 requires compli-
6 . 4 Safety and health requirements.
ance only with those OSHA r e q u i r e m e n t s that concern the machine itself. It
d o e s not require compliance with those OSHA requirements that concern the
m a c h i n e in its operating environment such as noise levels, radiation levels,
e l e c t r o m a g n e t i c emissions, noxious vapors, air contaminants, and heat. OSHA
l i m i t s the total hazard level of these hazards in the environment and does
The
n o t limit the hazard level of individual machines in the environment.
p r o c u r i n g activity is advised to analyze the existing hazard levels in the
proposed operating environment, a n d specify additional machine requirements
t h a t will integrate the new machine into its future operating environment.
T h e machine shall be equipped with all point-of-operation guarding normally
furnished as standard on the manufacturer's commercial machines supplied to
I f specific point-of-operation guarding is required,
the commercial market.
t h e procuring activity should specify the exact configuration of the guard
required, as in most cases, the guard configuration is dependent on the size
The above, a n d any other additional
a n d configuration of the workplaces.
s a f e t y and health requirements, s h o u l d be specified in detail under 6.2.1
(f) .
6 . 5 Cross reference of classification changes. Machine classification
c h a n g e s from the previous issue of this specification are as follows:
The numerical control requirements included in MIL-C-80036B have been delet-
ed. The requirements for a numerical control cutting machine, oxygen flame
and plasma arc, automatic, s t a t i o n a r y are now covered in new specification
MIL-C-80265.
14
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business