MIL-C-80036C
M e a n s shall be provided to insure adequate lubri-
3.2.10 Lubrication.
c a t i o n f o r a l l m o v i n g parts.
All oil holes, grease fittings, and filler
c a p s shall be accessible.
3 . 2 . 1 1 I n t e r c h a n g e a b i l i t y , A l l parts shall be manufactured to definite
d i m e n s i o n s and tolerances that will permit installation of replacement parts
w i t h o u t modification of the part or machine.
The machine shall be constructed of parts which are
3.3 Construction.
new, w i t h o u t defects, a n d free of repairs.
T h e structure shall be capable
o f withstanding all forces encountered during operation of the machine at
i t s maximum rating and capacity without permanent distortion.
A l l castings and forgings shall be free
3 . 3 . 1 Castings and forgings.
f r o m defects such as scale and mismatching.
P r o c e s s e s such as welding,
p e e n i n g , plugging, or filling with solders-or pastes shall not be used on
c a s t i n g s or forgings to reclaim any defective components for use on the ma-
Such processes may be used only for enhancing surface finish and ap-
chine.
pearance.
W e l d i n g , brazing, or soldering
3.3.2 Welding, brazing, or soldering.
s h a l l be employed o n l y where specified i n t h e o r i g i n a l d e s i g n .
None of
t h e s e processes shall be employed as a repair measure for any defective
part.
3 . 3 . 3 Fastening devices. All screws, pins, bolts, and other fasteners
Fastening
s h a l l b e i n s t a l l e d i n a manner to prevent change of tightness.
d e v i c e s subject to removal or adjustment shall not be swaged, peened, stak-
e d , or otherwise permanently installed.
A l l surfaces shall be clean and free of sand, dirt,
3.3.4 Surfaces.
f i n s , s p r u e s , f l a s h , s c a l e , flux, and other harmful or extraneous materials.
A l l edges shall be either rounded or beveled unless sharpness is required to
E x c e p t as otherwise specified herein, the
p e r f o r m a necessary function.
c o n d i t i o n and finish of all surfaces shall be in accordance with the manu-
f a c t u r e r ' s commercial practice.
U n l e s s otherwise s p e c i f i e d (see 6 . 2 . 1 ) , the machine
3.3.5 Painting.
s h a l l be painted in accordance with the manufacturer' s standard commercial
p r a c t i c e and color.
A l l threaded parts used on the machine and its related
3 . 3 . 6 Threads.
attachments and accessories shall conform to FED-STD-H28.
A l l gears shall be constructed from a material suitable
3.3.7 Gears.
f o r the intended purpose.
5
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business